Hi everyone. I've just updated my Bae146 and it's a great experience! However... since last update my communications are "strange"...

I tune airport ground for taxing: ground replies, and I can taxi. I tune tower for takeoff clearance: tower replies, and I can takeoff.

When I hear "you are leaving my airspace, frequency change approved"... Nothing more happens. Usually, my co-pilot contacts atc, which starts to follow me.
My transponder is still set on 7000, I can change numbers but if I don't know ATC squawk, no one talks.
If I turn knob on TA or TA/RA or other... nothing changes.
I always open atc menù, then choose 1, 2, 3, etc...
I try to change manually the com frequence and it still returns on tower frequence... also setting the frequence on the second knob and then switch, gives no result. Com volumes are 100%.
So ATC can't follow me... and... worst of all, I can't contact airport to ask permission to land.
Am I doing something wrong? Or it's a bug? Or did something change after last update?
Thank you for your answer.

@Thor_999 said in Buxton/Peak Forest Extension:

I've just bought the Buxton/Peak Forest extension. When i selected a quickdrive route from Tunstead Quarry to Leicester, there is a problem with the wagons that have been placed in the sidings at Tunstead. They block the tunnel mouth so that you cannot leave the sidings where you start this quickdrive journey.

Sounds like what I saw and mentioned up thread about the same starting point. I think you can delete the offending wagons via the editor as a workaround.