I'm trying to use spad.next to create a profile so I can use the trim wheel on my honeycomb bravo. The best way to do this is to use spad.next and use the increment/decrement elevator trim pos command as it gives you fine grain control over how much each click of the trim encoder moves the trim wheel in the aircraft. The problem is every input gets reset by the aircraft for example.

8c2f2ead-c582-48eb-a60e-3dc9b1cb4b77-image.png

You can see the trim position value gets reset back to 0.043712..... every time I add my increment by 0.02. Is this something the devs need to fix?

@Thor_999 said in Buxton/Peak Forest Extension:

I've just bought the Buxton/Peak Forest extension. When i selected a quickdrive route from Tunstead Quarry to Leicester, there is a problem with the wagons that have been placed in the sidings at Tunstead. They block the tunnel mouth so that you cannot leave the sidings where you start this quickdrive journey.

Sounds like what I saw and mentioned up thread about the same starting point. I think you can delete the offending wagons via the editor as a workaround.