I just wanted to pass on an issue and solution to an installation problem I had with Horizon GenerationX VFR Photoscenery (V2.0) and Revolution X just in case anyone else hits the same issue. As an aside, has anyone had any luck with JustFlight support recently? I submitted two tickets over the last week and haven't had so much as a confirmation. Maybe all on hols?

Anyway this was a fresh install of FSX (DVD) and SP1+SP2, followed by all 3 regions of Horizon VFR Generation X Photoscenery. I decided to get Revolution X from JustFlight to add to the mix but despite the installer claiming a successful install (the "Add" buttons came up and worked), I could find not Autogen scenery anywhere in-game. After a bit of digging it turns out the installer was getting horribly confused as to where it should put the *.agn files. This can be discovered by grabbing the RXCopy*.bat file from the RevolutionX directory while it's installing.

Firstly, it put all Texture folders under the 1.2m Photo resolution section instead of 2.4 Photo resolution where they should be. Secondly, it muddled up the areas for each volume. So what it put in Area 1 should be in Area 2, Area 2 should have been in Area 3, and it put Area 1's Texture folder in a seemingly random place (often in a completely different volume, once in FSX's Add-on directory). If anyone else hits this issue the best way to figure it out install one volume at a time and grab the RXCopy*.bat file as mentioned above and move the Texture folder to the correct place. I had to keep jumping into FSX to test I'd dropped it in the right place, but it doesn't take too long to fix.