Pa 28 Arrow 3 4 turbo P3d v 4 |
Post Reply |
Author | |
pirlote
Check-In Staff Joined: 10 Dec 2017 Points: 4 |
Post Options
Thanks(0)
Posted: 10 Dec 2017 at 1:01pm |
Hello to all member;
I am with windows 10 I just bought Pa 28 Arrow 3 4 turbo for P3d V4. 2 minutes after i takeoff, the fuel flow start slowly to decrease to 0 (but the fuel pression is in the green and the RPM remains at 2.500 and the fuel selector is on Left and i have enough fuel in both tanks and the propeler is full fine). This forces me to aboard the flighr. The download of the product took 1 hour could it be the reason for a bad download or is there a procedure or switch i have to apply ? Did any body have this type of problem. I thank you for any advise to help me pirlote
|
|
snave
First Officer Joined: 30 Oct 2011 Location: Southampton-ish Points: 351 |
Post Options
Thanks(0)
|
Apply carb heat
|
|
pirlote
Check-In Staff Joined: 10 Dec 2017 Points: 4 |
Post Options
Thanks(0)
|
Hello Snave i did not know there is Carb Heat on PA 28 arrov 3 4 turbo where is this thank you
|
|
Mace_RB
Check-In Staff Joined: 03 Jan 2018 Points: 21 |
Post Options
Thanks(0)
|
I have had this happen a few times. I think that it only occurs when I have overstressed the engine.
There is a warning light for overboost in the cockpit. I remember flying out of Alice Springs, Australia, and it was 105 degrees F, and I think i overtaxed the engine trying to pull an overloaded Arrow off the ground. I got off the ground, but with the pedal to the metal. I cleared a low hill, then attempted to climb out....wasn't happening. Eventually the engine wouldn't put out any power, and i went down. I don't know if that is a bug that sometimes occurs, or if it is a feature...I'm thinking it may be some sort of feature. Keep your mani pressure under 40 on takeoff and see if it never happens again.
|
|
pirlote
Check-In Staff Joined: 10 Dec 2017 Points: 4 |
Post Options
Thanks(0)
|
Hi Mace RB
Thanks for your answer your comments are right i found it a several days ago all ok
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |