Carb Heat ? Arrow III & Warrior II for X-Plane 11 |
Post Reply |
Author | |
Stagbeetle
Check-In Staff Joined: 27 Jan 2018 Location: Male Points: 2 |
Post Options
Thanks(0)
Posted: 27 Jan 2018 at 9:41pm |
Both the new Arrow III and Warrior II are lovely models. however in both the Carb Heat does not seem to work at all in X-Plane 11. When I map Carb Heat ON/OFF/Toggle to a controller button the Virtual Cockpit control does not move. I can toggle the Carb Heat lever in the VC, but only if I map it to 'Alternate Static Port Toggle'. This appears to only affect the Amps, as you would expect from the Alt Static Source. Carb Heat should affect the RPM, but it doesn't. I would be interested to hear if anyone else has this issue? (Also has anyone actually had their engine, in either model, run rough and stop due to ice in the carb?) Thanks. JF_PA28_Arrow_III_v1.21 JF_PA28_Warrior_II_v1.0 |
|
anthonye
P/UT Joined: 22 Nov 2016 Points: 124 |
Post Options
Thanks(0)
|
I noticed the same regarding the carb heat not effecting the Amps.
Unless it's correct also the primer knob does not move much, very small amount hardly an movement at all. This is not mapped to a button, I am using the Mose to move it. Anthony |
|
Martyn
Just Flight Staff Development Manager Joined: 31 Mar 2008 Location: Huntingdon, UK Points: 7615 |
Post Options
Thanks(0)
|
We will shortly be releasing an update to fix the carb heat issue. The primer is animated and uses the X-Plane logic for that system. Thanks Martyn
|
|
Martyn
Just Flight Ltd |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |