DC-3 operation explained |
Post Reply |
Author | |
goldratte
Check-In Staff Joined: 22 Jan 2015 Location: United States Points: 2 |
Post Options
Thanks(0)
Posted: 24 Jan 2015 at 5:39pm |
Hi!
I have some questions regarding the operation of the JustFlight DC-3- to bring this out at the beginning- I am new to flight sims AND I have read the manual (which leaves much to wish for...). Before I got the JustFlight DC-3 I had approximately ten hours in the MS FSX default Cub, Cessna and DC-3. I'd appreciate if someone could take some time to answer my questions! - How do I adjust the NAV/ADF radio frequency to VOR/DME points? If I turn the range knob to 100-190 kHz, the frequency selection wheel goes blank. - Where do I adjust the COMM frequency? - When I use feathering I have to restart the engine to come up on the revs again? Is this the same in RW? - Why do the parameters between the engines vary so much, although they run under equal settings? Is this just an attempt to simulate RW plane or can this be optimized? Thank you very much for your help! Goldratte
|
|
Expire
Check-In Staff Joined: 04 Dec 2014 Location: UK Points: 28 |
Post Options
Thanks(0)
|
Are you still looking for answers or have you sorted this out in the interim? I am by no means an expert but for a couple hours last night I was testing out the navigation systems.
Mike
|
|
Best regards
Mike Reardon |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |